Infocus SP-CEIL-010 Bedienungsanleitung PDF herunterladen

LISTED

E176225

27700B S.W. Parkway Ave.

Wilsonville, Oregon 97070-9215

1-800-294-6400

www.infocus.com

SP-CEIL-010 DIGITAL PROJECTOR MOUNT

nstallation Instructions

These are the installation instructions for your Digital Projector Mount. Included are four methods of

installation.

Select the method that works best for your viewing situation. The methods are:

° Fixed Height Ceiling Installation

—

best for short ceilings, eight (8’) or lower

° Adjustable Height Ceiling Installation

—

best for high ceilings, nine (9’) feet or higher

° SP-LTMT-EXTP-S height adjustable extension is required.

° Wall Mount Installation

—

for installing the Digital Projector Mount on a rear wall the

SP-LTMT-EXTP-S height adjustable extension is required.

NOTE: If the required height range is greater than 12½", the optional SP-LTMT-EXTP could be used to

extend the length of the suspension adapter. For further information or ordering assistance, please contact us

at the phone number and address listed at the top of this column.

Before You Start the Installation

The wall or ceiling where you want to install the digital projector must be capable of supporting a weight that is

five (5) times the weight of 7lbs the projector you are installing. Consult the projector’s documentation for

weight specifications. If the wall, ceiling, tabletop, shelf, or floor is not strong enough to handle five (5) times

the weight of 7lbs, then you must reinforce the installation environment. If you are unsure about the

installation environment, please consider having it reinforced and having the projector installed by qualified

personnel. Failure to do so could result in serious personal injury and damage to the projector.

To avoid personal injury, use only an approved projector mount. Using an unauthorized projector mount may

lead to poor ventilation and projector failure.

When installing the projector mount, keep in mind that the projector’s focus ring is not squarely in the center

of the front of the projector, but offset by several inches. Make sure that when you mount the projector you

offset the installation to match the amount of inches that the projector’s focus ring is offset from the center of

the front of the projector.

Hardware description

The Digital Projector Mount utilizes the following hardware. Note that the letters associated with the hardware

on this list correspond to the letters listed in the instructions for each installation method.

. Four

(

)

(

)

x 10

(

)

Philli

s head screws

(

lied

)

B. One (1) mounting bracket (supplied)

C. Digital Projector (not included)

D. One (1) Litemount Plus® assembly (supplied)

NOTE: Hardware item (E) is what secures the Digital Projector Mount to your ceiling, wall, tabletop, floor.

Make sure you consult with your local hardware store staff for the type of hardware that works best for your

installation environment.

E. SINGLE WOOD STUD: If mounting on a single wood stud use three (3) #14 x 2" Lag bolts (minimum)

commercially available. Use the mounting points on the center of the plate as indicated in the assembly

diagram.

° SOLID STRUCTURE: If mounting to a solid structure use four (4) 5/16" x 2" Lag bolts or commercially

available hardware (depending on the installation requirements). Use the mounting points found on the outer

points of the mounting plate as indicated in the assembly diagram.

F. Allen wrench (supplied)

1 2 3 4 5

Inhaltsverzeichnis

Seite 1 - Hardware description

Seite 2 - Lightmount Plus® Overview

(4) Solid structure mounting points (2) Cable access points (2) Tension knobs Screen side (Yellow indicator)

Seite 3 - Insert and rotate 180°

Ceiling plate Remove (M8) Hex head screws, flat washers and star lock washers Remove the center extension

Seite 4 - EE FIGURE

Adjustable Height Ceiling Installation Complete the following steps to install the projector mount and projec

Seite 5 - Wall Mount Installation

SEE FIGURE 4 Wall wood stud Wall structure D Adjustable extension E B C C B Adjustable screws Wall Mount Installation Complete the following steps

Kommentare zu diesen Handbüchern

Keine Kommentare

Infocus SP-CEIL-010 Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Projektorhalterungen Infocus SP-CEIL-010 herunter. InFocus SP-CEIL-010 User's Manual Benutzerhandbuch

Inhaltsverzeichnis

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Projektorhalterungen Infocus SP-CEIL-010