Infocus 620 Bedienungsanleitung PDF herunterladen (Seite 46)

Maintenance & Troubleshooting

•

Using a small, flat-blade screw driver, remove the two

screws on the bottom of the projector on the outside of the

lamp module cover.

CAUTION: Never operate the

projector with the lamp cover open

or removed. This disrupts the air

flow and causes the projector to

overheat.

•

Pull the lamp cover up and remove it.

FIGURE 35

Removing the lamp module cover

CAUTION: Be sure to replace

the projection bulb as soon as

possible after the lamp monitor

light comes on. If the lamp

remains in use too long, there is a

danger of lamp explosion. If this

happens, your LitePro will be

severely damaged.

4 Remove the lamp module.

• Lift the ring of the screw fastener up and turn it 1/4 turn

counterclockwise (the screw remains attached to the lamp

module).

FIGURE 36

Turning the ring of the screw fastener

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 69 70

Keine Kommentare

Infocus 620 Bedienungsanleitung Seite 46